Holland Jachtbouw pride themselves on paying meticulous attention to detail and ensure that every boat is finished to the highest caliber. This can be seen in IKARON, who has been beautifully maintained over the years.
IKARON can accommodate up to 8 guests in 3 cabins. Accommodation onboard is spacious and finished in beautiful blonde teakwood.
Vessel Name: IKARON
Builder: HOLLAND JACHTBOUW
Model Year: 2000
Year Built: 2000
Category: Sloop
Country: Italy
MLS #: 375914
Sleeps: 8
Staterooms: 3
Crew Berths: 4
Crew Sleeps: 4
Length: 30.48 (30.48m)
Draft: 11' 11" (3.63m)
Beam: 23' 8" (7.19m)
Cruise Speed: 9 Knots
Max Speed: 11 Knots
Water Capacity: 1532.2 Gal
Manufacturer: MTU
Model: MTU 6R 183 TE62 275 kW6 cylinder
Engine Hours: 6650
Engine Type: Inboard
Horsepower: 385
• Full beam with two double beds either side
• Luxurious en-suite bathroom, with stall shower
• Two double twin cabins port and starboard forward
• Port forward cabin is equipped with an en-suite bathroom
• Two bunk cabins port and starboard
• Crew mess with U Shaped sofa, all electric controls
• Crew bathroom that doubles as an en-suite for the port forward guest cabin
• Two helm stations equipped with all sail controls
• Fantastic 360º views over and along the deckhouse
• Large table with U shaped sofa in blue leather port side
• Navigation and transmission equipment starboard side
• Steps into the upper deck salon and lower deck salon
2021
• Mast and rig pulled out of boat and all rigging removed for inspection
• All running rigging replaced
• Cabling, lights, and electronics checked, serviced or replaced
• Hydraulic furles serviced and rebuilt by Rondal
• Hydraulic halyard rams serviced
• Hydraulic aft stay tensioners serviced
• Hydraulic boom van serviced
• Mast & boom re-installed and tuned
• New Furuno radar and navigators installed
• New PC screens
• New cockpit resolution waterproof monitor
• New B&G processor and triton
• New Gyro-track compass installed
• All batteries serviced and or replaced
2022
• New electric motor
• Variable pitch gear box taken out, dismantled and serviced. All new
• Marine gearbox “Twin Disc” taken out and rebuild, new seals &
bearings.
2023
• Under water Hull sand blasted, inspected
• Propeller, shaft, variable pitch system and gear box works:
• Variable pitch propeller “Teignbridge” dismantled and serviced
• Propeller shaft pulled out, taken to machine shop. Installed in lathe,
checked for wear & torsion, cleaned. Was in perfect condition.
• Propeller shaft bearings serviced. oil and water seals, both engine
room side and water side, all replaced.
• Propeller shaft oil bath oil replaced
• Propeller shaft aft “cutlass bearing” replaced
• Main engine rubber support blocks replaced (all 2 )
• Propeller shaft & main engine re-aligned. Boat sea trials showed
perfect alignment.
• Rudder pulled out full service
• Rudder lower and upper bearings serviced
• Steering system & steering quadrant serviced
• New bearing Laghersmith
• Zink anodes new
• Brand new sails
• New tender Geniuss 320
• Hydraulic swim platform
